sliqua-jcooter wrote:
Seriously?
I'm not the one who made that suggestion.
Quote:
The CAN bus is a 2-wire bus, you don't need a port, you just need a couple of alligator clips. Also, the engine CAN bus runs into the transmission, which means you likely don't have to pop the hood to get access, you just need some amount of time underneath the car while it's unattended.
The ground clearance of most cars and the fact that you'd have to remove several parts (sometimes the transmission itself needs to be removed) makes this difficult, never mind the fact that only someone incredibly stupid would jack up the car and attempt to do so without the gear typically found at a workshop. Messing with the CAN bus wires from below takes longer time than changing the oil (especially given that it's laid out differently for each car brand), and I'm aware of the fact that you do not need a port.
Quote:
Also, what's this BS about OBD-II bluetooth dongles being the size of cell phones? I have one permanently connected to both of my cars, and they're about the size of a pack of gum and easily fit behind the body panel covering the port.
Depends on what kind of device we're talking about. It doesn't invalidate my point on how it would be easy to detect a device like that in the car, though.
_________________
“He who controls the spice controls the universe.”